Optimizing misfit dislocation glide kinetics for enhanced threading dislocation density reduction in Si1−xGex/Si(001) layers through dynamic growth rate control
L. Becker1,2, P. Storck1, Y. Liu3, G. Schwalb1, T. Schroeder4,5, I.A. Fischer2 and M. Albrecht4
Published in:
J. Appl. Phys., vol. 135, no. 20, pp. 205303, doi: 10.1063/5.0204318 (2024).
Abstract:
Relaxed Si1−xGex layers on Si(001) serve as virtual substrates for strained Si or Ge layers. However, plastically relaxed layers inevitably contain misfit and threading dislocations, negatively affecting devices. Deposition of a SiGe layer on the backside of the substrate introduces a dislocation reservoir at the wafer edge that can reduce the threading dislocation density (TDD) of Si0.98Ge0.02/Si layers, as these preexisting dislocations start gliding toward the wafer center upon reaching the critical thickness. Here, we show that this low-strain system can be used effectively to study dislocation glide kinetics. In agreement with the literature, dislocation glide is a thermally activated process with an activation energy of 2.12–2.16 eV. Near the critical thickness, relaxation is sluggish and inefficient due to the linear dependence of the glide velocity on excess stress. At lower growth rates, dislocations from the edge reservoir are activated in a lower density due to the increase in the critical thickness through partial strain relaxation by already activated dislocations. Contrary to common models, here, the lowest possible growth rate is not essential for minimizing the TDD. Instead, a careful balance between low and high growth rates is beneficial. Overcoming the initial sluggish and inefficient relaxation phase is critical while also avoiding accumulation of strain energy, and, therefore, the activation of dislocation sources. Only in a later stage of buffer growth, the growth rate should be reduced to a minimum. With this method, the TDD of strain relaxed Si0.84Ge0.16 layers is reduced to 7 × 104 cm−2.
1 Siltronic AG, Einsteinstraße 172, Tower B/Blue Tower, 81677 Munich, Germany
2 Experimental Physics and Functional Materials, Brandenburgische Technische Universität Cottbus-Senftenberg, Erich-Weinert-Straße 1, 03046 Cottbus, Germany
3 Ferdinand-Braun-Institute (FBH), Gustav-Kirchhoff-Str. 4, 12489 Berlin, Germany
4 Leibniz-Institut für Kristallzüchtung, Max-Born-Straße 2, 12489 Berlin, Germany
5 Institut für Physik, Humboldt Universität Berlin, Newtonstr. 15, 12489 Berlin, Germany
Topics:
Crystallographic defects, Epitaxy, Etching, Optical microscopy, X-ray topography, Germanium, Silicon
© 2024 Author(s). All article content, except where otherwise noted, is licensed under a Creative Commons Attribution (CC BY) license (https://creativecommons.org/licenses/by/4.0/). https://doi.org/10.1063/5.0204318
Full version in pdf-format.